
PROCESSING OF LARGE LENGTH SHAFTS
Tadjibayev Rasul Karimovich , Candidate of Technical Sciences, associate professor at Fergana Polytechnic Institute Homidjonov Ma`murjon Ma`rufjon o`g`li , Master's student at Fergana Polytechnic InstituteAbstract
Shafts over 1.5 m long can be classified as long. Those of them that have a length-to-diameter ratio of more than 10 can be classified as non-rigid. The most characteristic shafts of high precision are the rods of hydraulic cylinders, boreholes of boring machines, cylindrical guides, shafts and rolling pins of various mechanisms, sliding and rolling screws, etc. Processing of such products requires the use of additional devices in machines to overcome the effects of deformations under the influence of cutting forces and gravity, as well as the risk of self-oscillation.
Keywords
precision, control, processing, detail, measurement, surface, orientation, machine tool, accuracy, direction, bench, scheme
References
| ISSUE 12 | 2021 ISSN: 2181-1385 Scientific Journal Impact Factor (SJIF) 2021: 5.723 Directory Indexing of International Research Journals-CiteFactor 2020-21: 0.89 DOI: 10.24412/2181-1385-2021-12-1384-1390 Google Scholar Scientific Library of Uzbekistan Academic Research, Uzbekistan 1389 www.ares.uz
Отақулов О. Х. и др. КОМПРЕССОР ВАЛЛАРИДАГИ САЛБИЙ ТИТРАШЛАРНИ БАРТАРАФ ЭТИШДА КИМЁВИЙ ТЕРМИК ИШЛОВ БЕРИБ ЦЕМЕНТИТЛАШ ЖАРАЁНИНИНГ МЕТОДОЛОГИЯСИ ВА АФЗАЛЛИКЛАРИ //МОЛОДОЙ ИССЛЕДОВАТЕЛЬ: ВЫЗОВЫ И ПЕРСПЕКТИВЫ. – 2020. – С. 312-316.
Todjiboyev R. K., Ulmasov A. A., Sh M. 3M structural bonding tape 9270 //Science and Education. – 2021. – Т. 2. – №. 4. – С. 146-149.
Файзиматов Ш. Н. и др. КИЧИК ДИАМЕТРГА ЭГА БЎЛГАН ЧУҚУР ТЕШИКЛАРНИ ДОРНАЛАР ЁРДАМИДА ИШЛОВ БЕРИШДА ЮЗА АНИҚЛИГИНИ ОШИРИШ //Science and Education. – 2021. – Т. 2. – №. 3. – С. 181-187
Отақулов О. Х., Ўлмасов А. А. Ў. Вал ва роторларни виртуал анализ қилишда САЕ тизимларининг ахамияти //Science and Education. – 2020. – Т. 1. – №. 1. – С. 235-240.
Article Statistics
Downloads
Copyright License

This work is licensed under a Creative Commons Attribution 4.0 International License.